Home / Guides / How to convert an image to DXF for laser engraving on a Mac

How to convert an image to DXF for laser engraving on a Mac

Trace a logo on your Mac, export a sized DXF or SVG, and open it in LightBurn, Glowforge or xTool Creative Space.

Laser software needs vectors, not a flat photo. If you want to engrave or cut a logo, you need a clean outline or filled shape at a real-world size, in a format your software can open. On a Mac, CleanCut Vector can trace the image on your computer and export DXF (R12), SVG or PDF in millimeters or inches.

DXF, SVG or both?

CleanCut Vector exports DXF R12, which is widely supported by laser and CAD tools, including LightBurn. Use DXF when your software prefers it, or when an SVG import is limited.

One honest caveat: DXF R12 stores curves as many small straight segments, so a very tight curve can look slightly faceted. SVG and PDF keep true Bezier curves, so they are often the better choice when your software accepts them. Glowforge and xTool Creative Space, in particular, usually work well with SVG. If you are not sure, export both and see which imports more cleanly.

Trace the artwork

  1. Open the largest, sharpest version of the logo or graphic. High-contrast art traces best; soft photographs are not what this is for.
  2. Choose black & white for a single fill or cut, or Auto / 2 to 8 colors if you want separate layers.
  3. Hit Trace, then check the overlay preview. Look closely at holes in letters and at any leftover specks. Raise speck removal or lower detail if the path is noisy, and trace again.

Export at the size you will actually run

  1. Pick the output preset that matches your software: LightBurn, Glowforge or xTool Creative Space. If you just need filled shapes or outlines, use Laser engrave (fill) or Vinyl / cut (outline).
  2. Set the real-world size and choose millimeters or inches. The units you export in should match the units your laser software uses when it imports the file. A mismatch here is the usual reason a design comes in too large or too small.
  3. Export DXF, SVG or both, then open the file in your laser software and confirm the size before you run the job.

If shapes come in as outlines when you expected a fill, set the layer to fill or engrave in your laser software, or export again with the Laser engrave (fill) preset as SVG. All tracing in CleanCut Vector happens on your Mac — nothing is uploaded.

A few practical checks

More import notes are on the Support page. If the same logo also needs to go on a cutter, see how to convert a logo to SVG for Cricut.

Try it on your Mac

CleanCut Vector is a one-time $9.99 purchase on the Mac App Store. Tracing stays on your Mac — nothing is uploaded, and there is no subscription.

Download on theMac App Store